Small Update:
I was able to spend a few hours over the long weekend on the cab. I finished the driver side rocker. You can probably see the miss fitment on both sides where the rocker meets the back side of the cab. I'm not sure how I am going to fix this yet, more than likely have to cut it and push the metal out and reweld.(LMC rockers don't fit the best) I then started back on the firewall. I tried 2 times to cut the metal to do an angled detail on the top wire channel. Both times I cut the radius piece wrong and it would fit right so I ended up cutting it off and throwing it to scrap. I'm either going to have to get some thicker sheetmetal (20-18 gauge?) The 22 gauge I'm working with is too thin and wants to warp to easy. Looked like crap! I may just scrap the whole idea for now. I'm ready to move on! I then started filling some more of the holes that won't be used on the firewall. Here are the pics:
Checking the driver rocker fit with a door:
Finished welding the rocker and ground the welds smooth.
Rocker panel primered
Prepping to fill holes
Plugs welded in place
Ready for primer