The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

OrrieG · 01-10-2011, 01:58 AM

I want the frame secure enough that it doesn't move and squeak. The back will be held in with 8 screws. I had it in and out half a dozen times fine tuning the fit, it just takes a few minutes. Corners will have clips screwed to the back for alignment and into the floor and upper flange thru the speaker and storage cutouts. The finish panels will snap in using a concealed clip at the top with screw fasteners at the bottom.

Big box is Lowe's or Home Depot, most home improvement places have it.

01-10-2011, 01:58 AM	#402
OrrieG Registered User Join Date: Jun 2006 Location: Idaho Posts: 8,800	Re: Lurker OrrieG Progress Pics I want the frame secure enough that it doesn't move and squeak. The back will be held in with 8 screws. I had it in and out half a dozen times fine tuning the fit, it just takes a few minutes. Corners will have clips screwed to the back for alignment and into the floor and upper flange thru the speaker and storage cutouts. The finish panels will snap in using a concealed clip at the top with screw fasteners at the bottom. Big box is Lowe's or Home Depot, most home improvement places have it. __________________ 1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project Last edited by OrrieG; 01-10-2011 at 02:00 AM.