The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**slomotion** · 01-06-2012, 06:23 PM

I got a piece of 1/8" round stock from the hardware store, bent hooks on both ends, but left room to incorporate a turnbuckle into it so I could maintain just a little tension. This made the lever pull positive, and stopped any potential for rattles. After all of that, I put the seat in the full back position and haven't had any reason to move it since.

01-06-2012, 06:23 PM	#6
slomotion Old Duffer Join Date: Mar 2003 Location: Maine Posts: 1,821	Re: Original Bench Seat I got a piece of 1/8" round stock from the hardware store, bent hooks on both ends, but left room to incorporate a turnbuckle into it so I could maintain just a little tension. This made the lever pull positive, and stopped any potential for rattles. After all of that, I put the seat in the full back position and haven't had any reason to move it since. __________________ '68 Short C20 Flatbed Dually w/ 292 4bbl, Langdon cast headers, and WC T5 trans. '81 G10 Shorty Van "Good judgement comes from experience, and a lot of that comes from bad judgement." Will Rogers "Under promise, then over achieve."