Quote:
Originally Posted by tiny2085
Just finished reading the whole build, and everything looks top notch !
Every new page I read I was hoping you would be test driving it. Lets just say I'm excited FOR you to drive that sled!! Keep the pictures coming too.
|
Thanks, its getting closer. I really hope to be driving it this summer.
I finished up mounting the ride height sensors, got the wire run for them and mounted the valve block mounted and the air lines cut. I have a little more to tidy up the wiring, but the hard part is done.
The valve block is going under the tank, the tank is pushed back in the picture. I think I am going to do the tank in the color match bed liner like the floor.
Was looking at the ac compressor and I have run into a problem. It fits, but there is no adjustment once the line is installed. If it goes toward the drives side, the line will hit the master cylinder, and if it goes to the passenger side, it hits the valve cover. I think I am going to take off the lug on the compressor and see if that works out, the only other option that I can think of is to change the master cylinder and I really don't want to do that.
