Quote:
Originally Posted by jocko
yep, I'm a little cornfused also. I am assuming that is just your manifold vac tee and you're hooking a hard line to the vac gauge where you have the brass fitting screwed in? If that is the case, you will need to account for eng vs body vibe as was mentioned above. Even if a hard line is used, there has to be rubber in the process somewhere to account for that. Or I might not be interpreting what you're doing correctly.
Thanks for posting EVERYone - this has been very helpful to me.
|
I am going to put rubber in between the two ends. I am going to have a hardline under the hood and run into the grommet where the oil pressure runs and from there put a piece of rubber through the grommet about one inch towards the motor and make it look like part of the grommet. cleans it up a bit and looks more factory I think. I will run a rubber hose on the inside to the line on the gauge so it will be easier to remove from the dash. Ill post a pic of the grommet when I have it out next.