Re: time for some upgrades
Your plans are very impressive as is your quick pace of progress.
Fyi heat lamps also work very well for cooking paint, and may allow better temperature control. I think the finned rear axle cover would look very cool (I have a chrome steel version myself). I’ve had my gears swapped twice, and both times silicone was used alone, and both times the cover leaked. The cover was pulled, cleaned up, and the best gasket I can find installed with no leakage at all. My axle is a Dana 44, not sure if they are more prone to leakage than anything else.
When it comes to deciding where to mount your cruise control module, it can go virtually anywhere. When I had cruise I mounted the module between the heater and distributor on the inside of the firewall. The instructions warn against mounting it in the cab, but all I ever noticed was a small “click” when it is turned on, and mounting it inside sure cleaned up the engine compartment.
Is there an overall picture of your truck posted somewhere? Does it look like your Avatar? Have a great week.
|