|
Re: How to tell if I have an HEI distributor?
oh yes, and do not tie into the existing wires , just run a heavy gage red wire from a Ingnition source from the fuse box to the distributor when you install it ,
make sure the fuse source only has power when the ignition is on
Easy install,
__________________
Mike
72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider.
421 SBC / TH350 3000RPM Stall
Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks 
|