[MP&C]

Kyle finishing up the prep on the door this morning, found another use for the GatorMeet radius square, here used as a sanding block to get into the tight crevices...





Front fenders were both prepped with DA and 80 grit..








SPI Epoxy is mixed to allow for induction...








As the body parts had been soda blasted, it was cleaned with a hot soapy water (dish detergent) and a grey Scotchbrite, followed by a towel drying session.





Then this was followed up with preclean...











The door handle backing plates had not yet been installed on the back side of the door skins, so a coat of epoxy was sprayed on both, and then bolted together to allow to cure..








A good shot of the door paint fixture in action...





Two coats applied...