[71blksuper4x4]

Thanks guys! I have been busy getting the patches installed around the back cab corners on that truck floor and installed a new rear cross member under it. Sandblasted the rust underneath it,just to know what was under it. I coated it with etch primer followed by another primer, than textured rock chip guard and paint. I didn't want to replace any of it in the next 15 years again. Then I went ahead and installed lower pillars and cab corners before putting in the floor, so I could grind down the welds from the inside first. The floor has another donor hump extending from the center to continue the look of the the low hump throughout the cab. Hopefully it will also give me an extra inch or two for clearance to for the transfer case if I need it. It will also act as a way to hold up the 2nd carpet kit in the center of the floor more like factory. Finally I added pieces left over from the burb floor I cut out to make the burb floor flow into the 2nd floor. So lots of work before getting to this point. I promise I'm not slacking!