[55 Chevy Dave]

Now that the holidays are over, it's definitely time to get back to work on the project.

After hunting high and low on the internet and looking through all of my catalogs, I was not able to find pedal plates for my truck, so I decided to make some.

I bought some Lokar billet aluminum pedal pads from Summit Racing. I made the pedal plates to fit inside these pedal pads. It wasn't too difficult as they only have a slight bend to them. I drilled the mounting holes and then made mounting brackets and welded them to the back side of the plates.

The pedal pads now screw to the plates.

I still need to take the die grinder to those ugly welds!