Quote:
Originally Posted by FirstOwner69
I modified a valve cove in a similar fashion as was suggested. It eliminates the oil mess when adjusting valves with the engine running. This is a picture of my "prototype" valve cover. The final version had better hole alignment.
|
x2, I have some like that with the holes lined up better, you can also cut out the entire section,not just the holes, then,while engine is running at idle, back off one rocker at a time,slowly turn the nut counter clockwise until it chatters loudly,now slowly turn clockwise until it is quiet,then slowly turn an additional 1/4 - 1/2 and you're done....on to the next...