|
Re: Is this a good hydraulic press?
Oh that is impressive but it's a bit out of my reach at the moment. I have no room to work on anything and no lathe. If I buy one I'll probably go for the Harbor Fake Tools version, it's popular on this thread and should do the job for me. Storing even it will be a challenge but I can take it back apart.
I may run over to Harbor Fake and see if they can order the unit for me or if they have one in stock, I printed out a 20% off coupon. (Thanks again to the member that suggested that).
I can weld a bit and my father has a welder, after I get some room I could weld the press together for square and put in some brass set screws to take out the play in the bar, as shown in a video I linked above.
|