Not much of an update I have been super busy with work and other small project and a little renovation.
I started tearing into the cab. removed the outer rocker.
[IMG]
IMAG0892 by
jarrod vanwinkle, on Flickr[/IMG]
Then I drilled out the rear of the floor to cab spot welds.
[IMG]
IMAG0895 by
jarrod vanwinkle, on Flickr[/IMG]
Then I cut out the old rear floor section and support.
[IMG]
IMAG0893 by
jarrod vanwinkle, on Flickr[/IMG]
[IMG]
IMAG0911 by
jarrod vanwinkle, on Flickr[/IMG]
I did a quick test fit
[IMG]
IMAG0912 by
jarrod vanwinkle, on Flickr[/IMG]
Looks like I will have to make a center floor section
[IMG]
IMAG0894 by
jarrod vanwinkle, on Flickr[/IMG]
So I decided to drill out the rest of the spot welds the mount the rear of the floor to the cab. I before I drilled them out I made some bracing.
[IMG]
IMAG0897 by
jarrod vanwinkle, on Flickr[/IMG]
So my current doors are shot so I picked up a set on CL That I thought were in good condition. But they had been poorly repaired. They replaced the outer lower skin and lap welded it together so I get to re do that and I may also replace the inner lower as well as it has a few small holes and speaker cut outs.
[IMG]
IMAG0898 by
jarrod vanwinkle, on Flickr[/IMG]
I also picked up a new fender that had been damaged right after it was installed its an easy fix my fender has a lot of bondo and rust.
[IMG]
IMAG0899 by
jarrod vanwinkle, on Flickr[/IMG]
I did a quick test fit of the door and fender
[IMG]
IMAG0909 by
jarrod vanwinkle, on Flickr[/IMG]
[IMG]
IMAG0910 by
jarrod vanwinkle, on Flickr[/IMG]
Also does anyone know what axle this is?
[IMG]
IMAG0904 by
jarrod vanwinkle, on Flickr[/IMG]
[IMG]
IMAG0905 by
jarrod vanwinkle, on Flickr[/IMG]