The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Andy4639 · 12-10-2019, 11:48 AM

Another problem I had was my rivet gun wouldn't fit inside the channel at some spots. I had to use washers to build it up but they didn't seem as tight as the other ones. I will look at building a tool for doing the passenger side. I may cut the tool in half and weld them to each side of a old c clamp that way it's narrow enough to fit inside the channels and other tight places.
If it works I may pull the drivers side back a part and redo it.

12-10-2019, 11:48 AM	#9
Andy4639 Old member Join Date: Jan 2002 Location: Liberty, & Garden City S.C. , U.S. Posts: 19,936	Re: Vent window repair Another problem I had was my rivet gun wouldn't fit inside the channel at some spots. I had to use washers to build it up but they didn't seem as tight as the other ones. I will look at building a tool for doing the passenger side. I may cut the tool in half and weld them to each side of a old c clamp that way it's narrow enough to fit inside the channels and other tight places. If it works I may pull the drivers side back a part and redo it. __________________ 1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver Seeing the USA in a 71 Upstate SC GM Truck Club 2013,14 and 2016 Hot Rod Pour Tour http://upstategmtrucks.com/ Get out and drive the truck this summer and have some fun! It sucks not being able to hear! LWB trucks rule, if you don't think so measure your SWB! After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs.