Re: Project: Montezuma
I think that if I had to do this over again on a high hump floor, I would get the regular floor and just cut the hump out.... You place the high hump on the floor and trace around it, add about an inch for a flange to bolt it down to and cut it out.
I have seen that done several times and they didn't have to fight the inner rocker issue. No way they are ever going to fix the stamp for the high hump floor. It would probably cost several hundred thousand. Typical to just claim ignorance like Brothers does on their rocker stamps.
CORRECTION: I wont do this again, Ill pay more for less rust. hah. But seriously, this was a decision to learn the hard way by choice. Now that ive done that, the next project (if I have one) I will take measures not to have so much rust repair.
|