Re: Project: Recycle
The angle looks better joint-to-joint. Not by much, but better regardless.
It actually wound up centering the shaft between the manifold flange & the C/O bracket upright (it was touching the rear upright of the C/O bracket).
I grabbed my angle template, centered it on the column housing, & adjusted the arm to align it as close as possible to the shaft. I checked the angle & it's close enough to 30° that it should work w/o bind.....
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|