Re: Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed
Quote:
Originally Posted by SCOTI
The cab is going to want to flex vs. the frame w/the standard bushings. But you want to tie the rear portion 'fixed/solid' mounted to the frame. I don't see that working well. You're likely going to need to swap to solid cab mounts.
A roll-bar for roll-over protection (cab roof caving in) & harness anchors can be attached to plates welded to the floor & function in that described manor. If you want to pass bars through the cab wall, all anchor points need to match.
How dead-set are you on the 'pass-through' bars to the rear frame section?
|
If i was to bag the rear section, what are you thinking?
|