Re: 2wd swap
Quote:
Originally Posted by KQQL IT
That isn't my issue with the Z my 68 was cut and stretched in like 74 I'm told.
Frame would need cut twice.
The z and then the core support.
Plus the engine mounts are all different.
Pass
Mild section drop spindles
Move the lower arms forward will achieve the look I'm after.
Appreciate the info.
This low low stuff is new territory
Always been a clip 2 coils and a flip it on all my C-10s
|
Ok. Only moving the lower arms forward helps w/improving caster. That's different vs moving the entire x-member which changes upper a-arm/lower a-arm/spindle hub centers together.
Moving the entire x-member forward starts encroaching on the steering box/Pitman & Idler mounting centerlines.
My dually has 3" spindles, a 1.5" sectioned x-member, & PB tubular 1" forward lower arms w/bags. Previously it used .750" forward GM a-arms w/coils (1 coil removed).
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
Last edited by SCOTI; 02-03-2021 at 04:53 PM.
|