The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Gregski** · 09-08-2021, 08:36 PM

so we threw it on there cab, like so...

just like the one that runs above the windshield it has two pinch welds on either side (where the vertical line is) so you can back cut the molding a 1/2 inch or so to get it on there flush or just have a tiny bump there

on the front one above the windshield I just so happened to have a perfect length strip to fit in between those pinch welds so I just ran three pieces, a middle one of about 2 feet and then the ones on either side above the doors

09-08-2021, 08:36 PM	#2090
Gregski Post Whore Join Date: Aug 2014 Location: Sacramento, CA Posts: 10,815	Re: A '54 named Busty so we threw it on there cab, like so... just like the one that runs above the windshield it has two pinch welds on either side (where the vertical line is) so you can back cut the molding a 1/2 inch or so to get it on there flush or just have a tiny bump there on the front one above the windshield I just so happened to have a perfect length strip to fit in between those pinch welds so I just ran three pieces, a middle one of about 2 feet and then the ones on either side above the doors Attached Images Last edited by Gregski; 09-12-2021 at 10:11 AM.