|
Re: Leaking master cylinder cap.
Quote:
Originally Posted by grubsster
Sure, I used the original cap from my old master cylinder which seemed to be of better material than the new master. Installed the retaining clips upside down in the vise and bent both sides inward, at the point where they go in the master, about 1/8th of an inch to "shorten" them a little. Used a 42071 dorman gasket.
Hope that helps.
|
That's good info for the next guy that has a similar issue. Appreciate the feedback.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|