Re: Boyd Tank Installation
The next step was to install the new hard lines. Before that could happen, I needed to remove the old hard line and mounting clips. I disconnected the original fuel line from the in-cab tank sender and ran the engine until the line was empty. I removed the flexible hose under the cab and removed the flexible hose from the fuel line to the mechanical fuel pump. I popped the frame line out of the clips and removed it from the truck. I pulled the tank hard line up through the grommet in the cab floor. I removed all of the old frame clips, including the two rearmost clips on the rear brake line.
Last edited by pjmoreland; 12-23-2021 at 02:50 AM.
|