Re: Boyd Tank Installation
I raised the tank most of the way into position and attached the flexible hoses to the rigid fuel lines. I also plugged in the wires. I was then able to adjust the positioning of the wires and then I zip tied them to the fuel lines.
I cut some pads out of rubber sheet and placed them between the frame and tank mounting flanges. The size of the pads are 12" x 2-3/8". I went with 3/32" thick rubber.
The tank could then be raised all the way into position and fastened to the chassis. I was able to view the fuel lines and wires from the wheel well to ensure nothing was getting pinched or kinked.
Last edited by pjmoreland; 11-22-2022 at 03:20 PM.
|