The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 47-59 Help Please

JayB22 · 06-15-2022, 05:26 PM

This is what had me thinking maybe I was okay with my setup. The rear ended is set to just over 6 degrees. Which would be its factory setting. With the driveshaft working out to be around 5 degrees and the motor just over 6. All of the angles play well with each other. And if this was FI it wouldn’t be a issue at all.

I’m going to pull the front clip off and see how far down I can drop the motor and start there. I’m not worried to tunnel the cab if it’s needed. I was just trying to avoid it if possible. Half the reason is I can’t find a way to remove the seat bracket. Haha. I might dive back into that as well.

06-15-2022, 05:26 PM	#92
JayB22 Registered User Join Date: Apr 2022 Location: Rocky View County Posts: 54	Re: Help Please - 4x4 S10 swap questions This is what had me thinking maybe I was okay with my setup. The rear ended is set to just over 6 degrees. Which would be its factory setting. With the driveshaft working out to be around 5 degrees and the motor just over 6. All of the angles play well with each other. And if this was FI it wouldn’t be a issue at all. I’m going to pull the front clip off and see how far down I can drop the motor and start there. I’m not worried to tunnel the cab if it’s needed. I was just trying to avoid it if possible. Half the reason is I can’t find a way to remove the seat bracket. Haha. I might dive back into that as well.