|
Re: wire splitter
Best bet trial and error.
First to figure out the terminal and size
Buy ebay hydraulic crimper
Try crimping 2 10ga wire together and pull test.... the trial and error part
If ok, final product i would peel a little more than the terminal length on the middle of the wire where the new wire branches off of, slide the splice connector on it, then insert the other wire and them crimp it. No need to have 3 wires to make it.
Heat shrink it with good adhesive lined heatshrink
2 10 ga might be like 8ga connector?? Parallel splice is what i use for my 3 relay fan setups for the fan wiring.
Clint
__________________
1987 Silverado - L83 5.3 w/ 6L80e ,A/C,P/W,P/L,TILT, HID projectors, Wilwood C-10 Pro Spindles w/ 2018 silverado front brakes & C-5 Corvette Rear Disc Brakes
1999 BMW 528i - 5.7 LS1 w/ 4l60e, Ford 8.8 IRS w31 spline posi & FX-r projector retrofit
New project: 2006 BMW x5 6cyl AWD to L83 6l80e 4wd to 2WD / RWD
A poor man buy's it twice
finally got my domain name back, 87chevy.com.... site rework in progress
|