View Single Post
Old 07-27-2022, 12:27 PM   #4
72c20customcamper
Registered User
 
72c20customcamper's Avatar
 
Join Date: Jul 2018
Location: Catskill Mountains,NY
Posts: 8,199
Re: 1968 GMC 250 Inline 6 4.1L Chugging

Quote:
Originally Posted by 68gmcdude View Post
I've reached the end of my patience... ��. My 250 inline 6 starts and idles fine. It will run down the road like a champ for a mile or two then start chugging and backfiring real bad. When I let off the gas it idles fine then it starts chugging and backfiring again a little ways down the road. Here is everything that has been done...

New gas tank and sending unit 3 years ago
Carburetor professionally rebuilt fall of 2020
Distributor professionally rebuilt fall of 2020
New cap, rotor and points
New AC Delco plugs and wires last summer
New coil this spring
New fuel pump (last summer and again yesterday)
New fuel lines
New carburetor fuel filter (last summer and yesterday). Old ones looked good.
New vacuum advance line for distributor to carb

I'm going to pull the sending unit out of the gas tank. It's been suggested that maybe the sock filter has collapsed (?).

Any other suggestions or possible issues are greatly appreciated! Thank you!
We used to shoot a little low pressure compressed air into the line not a lot just a quick shot to blow out crap in the sock . Leave the cap off while doing it .

My 68 327 did this when going up hills and at near WOT . Turned out the rubber line going from the pump to the frame hard line was collapsing
__________________
Mark
72 c20 custom camper Husky edition,
66 SS396 Chevelle 1964 Hawk, 63 Avanti,62 lark
1969 AMX ,
1968 c20 stepside ,85 K20
1977 Suburban sold
68 anniversary.
72c20customcamper is offline   Reply With Quote