|
Re: Help interpreting ALDL data
I’ve been busy. The battery died, so I have replaced it. I found a vacuum line to the charcoal cannister disconnected so I hooked that up. It was a hot day yesterday and I ran the truck for awhile, but it is not reading over 183 degrees. I’ll see if it gets higher when I drive it down the road. It may be awhile before that happens since it needs the glass and latches installed.
The WinALDL window has 9 tabs; Help, Raw Data, Flag Data, Sensor Data, Error Codes, BLM, INT, O2, Spark Counts.
Here is a screen shot of the Sensor Data, and Raw Data. I also recorded the Log Data and placed it in a spreadsheet. I started the Log capture before starting the engine, with the engine hot. It idled somewhat low until I gave it some gas.
I could see some values changing in the Sensor Data tab. The TPS, and IAC changed as I stepped on the gas pedal.
I see I can't attach the spreadsheet...
|