The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 47-55.1 S-10 swap - Clutch & Brake pedal (& master cylinder question)

b-mac · 01-04-2023, 10:35 PM

Back after a long absence. I've found a manual transmission for my truck (49 - S10 - LS).

I'm installing an AR5 from a Colorado/Canyon. If you're not aware of this setup, check out FABBOTFAB.COM. I plan to do a little thread on the install as there is less info out there than you would expect. Uses the 4L60 bellhousing. I've been told that it is almost exactly the same length as the automatic. And guys are apparently getting 700HP out of these transmissions.

MY QUESTION FOR YOU GUYS:

I've currently got the automatic brake pedal installed hanging from the stock, modified bracket.

I need to swap to a brake and clutch pedal set-up with a hydraulic clutch master. cylinder.

HOW WOULD YOU DO IT?

S-10 oem pedal? Master? Aftermarket? Combination? Vertical or horizontal...interior or engine-bay master?

Any help is appreciated greatly.

If any if you guys have pics of your setup, that would be awesome.

01-04-2023, 10:35 PM	#1
b-mac Registered User Join Date: Mar 2014 Location: Wichita Posts: 516	S-10 swap - Clutch & Brake pedal (& master cylinder question) Back after a long absence. I've found a manual transmission for my truck (49 - S10 - LS). I'm installing an AR5 from a Colorado/Canyon. If you're not aware of this setup, check out FABBOTFAB.COM. I plan to do a little thread on the install as there is less info out there than you would expect. Uses the 4L60 bellhousing. I've been told that it is almost exactly the same length as the automatic. And guys are apparently getting 700HP out of these transmissions. MY QUESTION FOR YOU GUYS: I've currently got the automatic brake pedal installed hanging from the stock, modified bracket. I need to swap to a brake and clutch pedal set-up with a hydraulic clutch master. cylinder. HOW WOULD YOU DO IT? S-10 oem pedal? Master? Aftermarket? Combination? Vertical or horizontal...interior or engine-bay master? Any help is appreciated greatly. If any if you guys have pics of your setup, that would be awesome.