[Peanut74]

Well since my filler neck interference issue has been resolved I started working on the fuel filler neck. Attached you see the steps that I took to get my fuel filler in. I did have to remove two brackets to get it all to work. One bracket was in the stake post hole about 6" down. The other one was on the bed rear sill rail.

Tomorrow I am planning on cleaning up the edges cuts and Trim some more off where the hose takes a 90 degree bend. Then weld in all in on the top and grind it down flush.

Here is what I used:
-Bikers Choice paintable popup gas cap P/n:011900
-1.5" ID steel pipe for filler
-1999 Honda Camry fuel filler (Use it to go from 1.5 to 1.25 dia)
- 45 degree 1.25" ID fuel filler hose from Fuel Filler Supply Co. p/n125A45
- 90 degree 1.25" ID fuel filler hose from Fuel Filler Supply Co. p/n125A90
- 1/2" ID hose for fuel vent