[Honest Bob]

I had to swap out the rear backing plates to the 80's type to match the m1010 frame ebrake setup. These were a hard to find item (the 1 ton 3.5" backing plates are not being reproduced as far as I could find) but ebay to the rescue.

The transfer case has been installed removed and installed again (forgot to install the gasket between the np205 and trans the first time causing a massive leak).

I put together an exhaust system using some ebay knock off hooker ls swap manifolds, Hooker manifold to exhaust adapter 520-70701403-R, Hooker 520-16526 exhaust system with some Hooker 520-21005 mufflers and a Jegs H pipe kit. It fit suprisingly well and was even able to fit a stock sized spare tire.