[seik5]

I do not have a 205, It was a 203 with a part time kit and twin sticks, jurry rigged in there with an altered 205 cross member. No where close to center. It was so crooked they had re drilled the engine mount bracket to get it to bolt down???Im starting over-- transfer case and driveline out (oh yes and drive lines not properly clocked either) transfer case on the ground pulling a used 205 and crossmember from another truck. Once I get that done I will get my pinion angle. Then go back and address the 14 bolt rear end. They had removed and rewelded the perch brackets, but they look to be about 1" out of center. If my angle is wrong as well, I will reweld perches and get everything "right." I hope my photos attach. Thanks for the help Link!