[northerngmc]

So 2 months later I am putting on the wheels! Tdot Performance was cheaper, but a real pain in the ass.....

I wanted a wheel with some bronze to go with the truck. But bought black and decided to play with bronze Plasti dip.

Any opinions? I will try and post pics later, I guess I can’t from my phone sitting in the garage...


So my real problem is the rear hubs being too long for the centre caps. The centre cap bottoms out on the end of the axle a good 1/2” before the centre cap touches the wheel. I don’t think I have the stud room or fender room to push the 265 65 R18 out by using a wheel spacer between the drum and wheel. Any ideas for a common product that could be modified to basically make a washer that is 5” inside diameter and 1/2” thick to use as a spacer?
Posted via Mobile Device