[JJH Jimmy]

Ok. I have not been updating as i should. I have been working on this when time allows. I got the transmission in and the transfer case re sealed and took it for a drive. It runs and shifts great. But, there is a clunking noise in the transfer case when it is in 4wd or in 2wd with the hubs locked. So that narrows it down to the output shaft. I noticed before i took it apart that it seamed to "catch" when i was spinning the output shaft with my hand? Everything looked good inside it and after i put it back together it spun smooth. Long story short, it is going to have to come out again. my guess is one of the bearings is bad. No big deal the body is coming off and i have the parts truck transfer case sitting in the corner.