Re: Hood wont close
Quote:
Originally Posted by lynx5653
Ok this is what I have done so far.
Put truck on jack stands leveled frame best I could
set cab same distance from frame . It does not show cab being level. To level cab I would have to raise front of cab well over an inch in front for cab to be level.
Set cab same distance side to side on frame.
Question is does cab have to be level or just set level to frame ?
|
I would say that the cab should be parallel to the frame. So, if you have the frame level, then make the cab level, it will be parallel to the frame. Or you can just make the cab parallel to the frame - if you have some rake in the stance of your truck, then the frame will not normally be level, it will be higher in the rear.
__________________
53 Chevy 3100, SBC 355, 700R4, S10 frame, Ford 8.8 rear with 4.11 gears, front disc & rear drum brakes
|