Finally got som e time to start working on the burb again!
Been buttoning-up a few loose ends, nothing major though. Passenger side header is in place. New motor mounts (which helped the header clearance issue). New A/C arrived, so I pulled old heater/fan junk, and got the brackets painted. Alternator bracket mod pretty much complete.
I pulled the front back apart so I can weld-up the lower bag cups I fabbed-up.
Here's the photos of them. I used some 4x4 box steel I had laying around, and contoured the bottom edge to fit the spring pocket, and sit flush. The plates I cut/salvaged from the extra rear mounts I don't need.
So after this lunch and computer break, Im off to drop of the boy at football, run to the hardware store $$$$.... Then back for some welding