[neolowrider]

did you say you where guna paint with a lil compresser? i wouldnt. 1 a small one will never be able to keep up with the ampunt of air u need to paint. 2 when it runs low you get spater and u dont want that. 3 most small comp. dont has water seperation. 4 a small tank will suck in over spray and push it back out through the gun and make the paint look bad. plus it will get inside the comp and can make it run harder and hotter and even break it.

if you are going to paint with it i would rec that u use low pressure gun, put the comp outside away from where u are painting. mix all yur paint at once but spray each section one at a time. this will keep u from trying to push your self and running short of air. sweep up real good and wet everything down and sweep again. keep the ground and whatever you can wet while you paint in your area to keep dust from flying around and getting everywhere. good luck with the build and paint.