had a little more time this weekend to work on the truck. All of the parts that i had ordered came in so i was able to make a little bit of progress. I got the column back together(helps when you have the right tools) my junk yard steering wheel on, passenger side tank swapped out(still watching the pick and pull inventory for another set of tank brackets) new fuel pump/sender installed. I thought i was going to be able to run the truck, but it had other ideas. I hit the key and it was rolling over but was not getting fuel, pump was running and when i looked under the truck it was misting fuel out of the transfer valve
a new one should be arriving today. my only concern is that it might be the rubber/hard lines with a pin hole. What does everyone do to repair the lines going into the valve?