[SCOTI]

Originally Posted by 3x2GTO

The swap is all done, working on getting it wired up now. I used all the big block mounts, frame stands clam shells etc... which sat the engine about an inch higher than the original small block parts would have. I had it for sale on FB as an EZ project, but no bites, so I'm going to get it running and drive it this year. Still have to get the correct slip yoke, driveshaft cut, grille, new tires, exhaust and whatever it needs to pass inspection. Thanks for the replies!

Running & driving will help the sale pitch for sure. More than a few potential buyers won't pony up the necessary funds when they can't hear the project run. The most common advertisement line of "it just needs 'this & that' to be great" is a big watch-out for me unless I'm familiar w/the seller.