View Single Post
Old 09-14-2018, 02:32 PM   #25
Almost Satisfied
1971Stepside's Avatar
Join Date: Mar 2002
Location: Springfield, MO
Posts: 2,794
Red face Re: 1971 Stepside LS Build

Some more of the same. I put the intake on the engine. I can't wait to get this thing put in the frame, but by the tone of the wife it will be awhile So, I guess I will start fabricating the gas pedal in the cab until I have the funds to buy the new torque converter. I will drop the pan off of the transmission and change fluid. Any recommendations on what fluid to go back with?

Yes, the crank pulley is just sitting there and not fully seated.
Attached Images
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021.

"I can't complain, but sometimes I still do. Life's been good to me so far."
1971Stepside is offline   Reply With Quote