The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**aotte1** · 04-19-2021, 11:59 PM

A few more power washed. Note, the rod end that connects to TC lever is not welded to rod straight. It has an angle offset. Photo four shows offset better. This offset is same on 1964 K10 truck shown also in photo 4 coated. The 1964 rod shows more angle in photo 4, because it is rotated more to show offset angle. Both appear to be same angle.

04-19-2021, 11:59 PM	#82
aotte1 Senior Member Join Date: Oct 2013 Location: lousiville Ky Posts: 2,637	Re: 1966 GMC K10 Suburban Project A few more power washed. Note, the rod end that connects to TC lever is not welded to rod straight. It has an angle offset. Photo four shows offset better. This offset is same on 1964 K10 truck shown also in photo 4 coated. The 1964 rod shows more angle in photo 4, because it is rotated more to show offset angle. Both appear to be same angle. Attached Images Last edited by aotte1; 04-20-2021 at 12:35 AM.