So i made some cab mounts. Basic as my fab skills are very basic.
after test fitting the cab and being happy with how it was sitting i burnt em all on with the MIG. I really struggled with the vertical up welding.
But the cab will be coming off a few more times so i will grind off the poo and try do a better job at a later date. I was too existed to have the cab bolted to the c30 chassis.
I want this to be low so I was happy to see that with the cab mounted the sills were hanging lower than the chassis.
I also ordered some slam SS7 airbags and have a set of drop spindles here to install.
My question to you fine folk is;
I think I want to run rack and pinion steering. So should I bite the bullet and order a porter built drop member? do they work with factory control arms?
Or am i better off just getting a rack and pinion kit from unisteer or something? I was doing some reading on here and saw people had issues with the unisteer when running an LS motor which I may well end up doing also.
Thanks guys