[hugger6933]

You can use all gm stuff like the 6 lug rotors and spindles and the 68 lower control arms use the newer ball joints and tie rods and then the calipers and all of the stuff will work. But I have gathered all of these parts well just from not throwing junk away cause I have a 95 3/4 ton that I junked and had the whole front suspension. the problem is when you build the truck it all looks and fits together real good and everything gives you a warm and fuzzy feeling then when you get farther along on the project and get it on the road, take it to get a front end aliginment it can't be done it is too far out of spec to get close with shims. Nobody on here that I have heard of that has used this set up has been able to get the steering lined out that I know of, it may have happened while I was sleeping but I just think your better with some aftermarket of the shelf stuff.