The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**AussieinNC** · 09-18-2017, 09:17 PM

Ok, sounds like the release fork that sticks out of the bell housing has come off its pivot point.

Post pics of the piece sticking out of the bell housing and the rod and z link, the cross tube.

Did you put a pilot bearing in the end of the crank.

09-18-2017, 09:17 PM	#2
AussieinNC Moderator Join Date: Jun 2017 Location: Cherryville, NC Posts: 2,156	Re: Clutch Problems Ok, sounds like the release fork that sticks out of the bell housing has come off its pivot point. Post pics of the piece sticking out of the bell housing and the rod and z link, the cross tube. Did you put a pilot bearing in the end of the crank.