View Single Post
Old 11-29-2020, 08:51 PM   #216
washington blue
Registered User
 
Join Date: Mar 2016
Location: Not far from Sioux Falls South Dakota
Posts: 321
Re: norms 55 chevy pu build

Thanks, the article says that if the engine is tilted back only front steam ports are needed. This engine has just front steam ports. I plan to have the tail shaft coming out of the transmission tilted down about 5 degrees to match the 5 degree upward tilt of the pinion gear. Is 5 degrees enough to use just 2 front steam ports? Also 5 degrees is with no load on the front springs.

Last edited by washington blue; 11-30-2020 at 12:39 AM.
washington blue is offline   Reply With Quote