The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

LS short box · 06-13-2021, 04:56 PM

When I did the LS/T56 magnum in my 68 I had to trim the trailing arm cross member for drive shaft clearance. I was able to get the engine angle down to 3.5 degrees. Stock high hump. Hind site 20/20 I would of lowered the engine just so the oil pan cleared the steering and wasn't below the engine cross member.

06-13-2021, 04:56 PM	#44
LS short box Registered User Join Date: Jun 2015 Location: Carlos MN Posts: 1,927	Re: LY6/TR6060 Swap from a 5.3/4L60E When I did the LS/T56 magnum in my 68 I had to trim the trailing arm cross member for drive shaft clearance. I was able to get the engine angle down to 3.5 degrees. Stock high hump. Hind site 20/20 I would of lowered the engine just so the oil pan cleared the steering and wasn't below the engine cross member.