[gottattooz]

I transferred my card board templates to sheet metal today. The wiper cowl delete, cowl-to-cowl cover and the left and right rear fender well filler panels are ready for trimming and shaping.

The wiper cowl delete panel is pretty simple as it's just a flat panel that will cover the vent holes under the finned cover.

The cowl to cowl panel has a curved radius, so i had to make relief cuts to allow the metal to bend across the top. Now that they're secured in place with self-tapping screws, I'll tack weld the bottoms and remove it to fill in the seams of the relief cuts.

I haven't fitted the rear fender well panels yet.

-Josh