Re: Over 25 Years Later, Finally My 71 C-10 Truck Build
Quote:
Originally Posted by hgs_notes
Thanks
It is a good starter, aint it? Way better than the my out of square, poorly patched original.
I got the pass side floor pan fit in. I figured it would be easier because I just did the other side and had the experience. It wasn't. The pan just did not fit in as well. Took a lot of beating and a few extra screws to get it pulled in tight.
So next I need to get me some glue and the applicator, clean some steel to bare metal, set up a heater and see what happens.
|
looking good hgs
__________________
:Chevy: If you don't run your own life,, some one else will.
to our vets,, welcome home,, and thank you for your service.:Chevy:
|