Quote:
Originally Posted by dsraven
It may be easier to cut off the bad patch, clean the area nicely on both sides of the metal so no contaminants get sucked into the weld, then fit up a new piece, one piece patch is better, then do the tack weld technique and take your time. Maybe less time spent and get a better result.
|
Cut it out yesterday and was conisering the 16ga when the welder blew. Sounds like an internal gas line .... will have to look and order a part or new welder.
So on hold.
I think this was the right move ....... Ill try and a cut and preform a piece that fits good prior and take a lot more time getting it into position correctly and hammer/dolly/cool as I go etc.
WIll psot an update but might be a while given ^^
thx all