[gringoloco]

With the floor out of the way and the 3" worth of block(2" + 3/4" + 1/4" ECE panhard bracket), I got a better idea of where the axle would end up. Problem with going this low with trailing arms is that the axle moves forward about an inch. This would not work for me so I drilled 10 more holes in the frame and moved the trailing arm crossmember back an inch. This was also a good time to install the ECE crossmember. It was the low point of the frame; now it's the tranny x-member, but that will be remedied when the Dropmember goes in. It also gave me a little more driveshaft clearance.