The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed

88Stanger · 04-11-2020, 07:58 PM

Ok, so i pulled the trigger and bought the No Modification Required bolt in Powered Rack & Pinion from POL. its like, if i am going to do this, go all out, to some extent.

Also, i bought an aluminium finned differential cover from Jegs. Well, when i put the rear all the up into the c-notch the track arm hits the cover, bad. So, i am thinking that i will just need to stick with stock. Sucks because i really like it, but oh well. I may see if i could grind off part of the fins, but i just hate doing this kind of thing. If it does not work the way it was maid, maybe that is a sign to just go with stock.

04-11-2020, 07:58 PM	#99
88Stanger Registered User Join Date: Mar 2015 Location: Washington State Posts: 1,644	Re: Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed Ok, so i pulled the trigger and bought the No Modification Required bolt in Powered Rack & Pinion from POL. its like, if i am going to do this, go all out, to some extent. Also, i bought an aluminium finned differential cover from Jegs. Well, when i put the rear all the up into the c-notch the track arm hits the cover, bad. So, i am thinking that i will just need to stick with stock. Sucks because i really like it, but oh well. I may see if i could grind off part of the fins, but i just hate doing this kind of thing. If it does not work the way it was maid, maybe that is a sign to just go with stock.