|
Re: blazer project
My "L" shaped rig for tipping it has some old exhaust pipe welded on that the bolts go through. Actually i had to use threaded rod because in the rear the bolts had to be 12 inches or so. I did not have any of the bolts bend. It does not touch the body on the bottom side but i had to make it real close so i would have room to tip it with my low ceiling. Once it was tipped up i used blocks under my cross braces that were across the top of the bed for extra support. Also i used a rope to ease it over when tipping ,i did it alone, but if you have help it would be cake without it.
|